Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH

VSC OFF SWITCH > INSPECTION

for Preparation Click here



1. INSPECT VSC OFF SWITCH


    C172889E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (E) - 6 (OFF)
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (VSC OFF Switch)
    If the value is not as specified, replace the VSC OFF switch.