Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH

DOWNHILL ASSIST CONTROL SWITCH > INSPECTION

for Preparation Click here



1. CHECK DOWNHILL ASSIST CONTROL SWITCH


    C172874E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (E ) - 4 (+B2)
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Downhill Assist Control Switch)
    If the result is not as specified, replace the downhill assist control switch.