Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › TRACTION OFF SWITCH

TRACTION OFF SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TRACTION CONTROL SWITCH (A-TRAC SWITCH)


    C214850E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (E) - 8 (ATRC)
    Pressed
    Below 1 Ω
    Not pressed
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (A-TRAC Switch)
    If the result is not as specified, replace the traction control switch (A-TRAC switch).