Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK

FRONT DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR LOCK ASSEMBLY LH


  1. Check the door lock motor operation.



    1. Apply battery voltage to the motor connector and check the operation of the door lock.


      B184438E10


      Text in Illustration 
      *a
      Lock
      *b
      Unlock
      *c
      Component without harness connected
      (Front Door Lock Assembly LH)
      -
      -

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      1. If the result is not as specified, replace the front door lock assembly.

  1. Check the detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      8 (LSSR) - 7 (E)
      Lock
      10 kΩ or higher
      8 (LSSR) - 7 (E)
      Unlock
      Below 1 Ω

      1. If the result is not as specified, replace the front door lock assembly.



  1. Check the door lock and unlock switch.



    1. Measure the resistance according to the value(s) in the table below.


      B184437E14


      Text in Illustration 
      *a
      Lock
      *b
      Off
      *c
      Unlock
      *d
      Component without harness connected
      (Front Door Lock Assembly LH)

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      9 (L) - 7 (E)
      Lock
      Below 1 Ω
      9 (L) - 7 (E)
      10 (UL) - 7 (E)
      Off
      10 kΩ or higher
      10 (UL) - 7 (E)
      Unlock
      Below 1 Ω

      1. If the result is not as specified, replace the front door lock assembly.



2. INSPECT FRONT DOOR LOCK ASSEMBLY RH


  1. Check the door lock motor operation.



    1. Apply battery voltage to the door lock motor connector and check the operation of the door lock.


      B184439E10


      Text in Illustration 
      *a
      Unlock
      *b
      Lock
      *c
      Component without harness connected
      (Front Door Lock Assembly RH)
      -
      -

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      1. If the result is not as specified, replace the front door lock assembly.

  1. Check the detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      7 (LSSR) - 8 (E)
      Lock
      10 kΩ or higher
      7 (LSSR) - 8 (E)
      Unlock
      Below 1 Ω

      1. If the result is not as specified, replace the front door lock assembly.