Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK ASSEMBLY LH


  1. Check the door lock motor operation.



      B164415E08
    1. Apply battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      If the result is not as specified, replace the rear door lock assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Rear Door Lock Assembly LH)
      *b
      Lock
      *c
      Unlock

  1. Check the detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Lock
      10 kΩ or higher
      6 (LSSR) - 9 (E)
      Unlock
      Below 1 Ω

      If the result is not as specified, replace the rear door lock assembly.



2. INSPECT REAR DOOR LOCK ASSEMBLY RH


  1. Check the door lock motor operation.



      B164416E07
    1. Apply battery voltage to the door lock motor and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (L)
      Battery negative (-) → 1 (UL)
      Lock
      Battery positive (+) → 1 (UL)
      Battery negative (-) → 4 (L)
      Unlock

      If the result is not as specified, replace the rear door lock assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Rear Door Lock Assembly RH)
      *b
      Unlock
      *c
      Lock

  1. Check the detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Lock
      10 kΩ or higher
      6 (LSSR) - 9 (E)
      Unlock
      Below 1 Ω

      If the result is not as specified, replace the rear door lock assembly.