AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the G49 radio and display receiver assembly connector.
Disconnect the G39 No. 1 stereo jack adapter assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G39-7 (ARO) - G49-26 (VAR+) | Always | Below 1 Ω |
| G39-8 (ALO) - G49-28 (VAL+) | Always | Below 1 Ω |
| G39-9 (ASGN) - G49-27 (VA-) | Always | Below 1 Ω |
| G39-10 (AUXO) - G49-25 (ADPG) | Always | Below 1 Ω |
| G39-12 (AGND) - G49-11 (AGND) | Always | Below 1 Ω |
| G39-7 (ARO) - Body ground | Always | 10 kΩ or higher |
| G39-8 (ALO) - Body ground | Always | 10 kΩ or higher |
| G39-9 (ASGN) - Body ground | Always | 10 kΩ or higher |
| G39-10 (AUXO) - Body ground | Always | 10 kΩ or higher |
| G39-12 (AGND) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||