Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR

AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT NO. 1 PRESSURE SWITCH


    I033643E02
  1. Connect a manifold gauge set.

  1. Connect the positive (+) lead from the ohmmeter to terminal 1 and the negative (-) lead to terminal 2.

  1. Measure the resistance between terminals when refrigerant pressure is charged, as shown in the illustration.
    If operation is not as specified, replace the pressure switch.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Pressure Switch)
    *b
    Low Pressure Side
    *c
    On (Below 1.0 Ω)
    *d
    High Pressure Side
    *e
    Off (10 kΩ or higher)