Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

The navigation receiver assembly sends a sound signal to the stereo component amplifier assembly via the sound signal circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, DCM (telematics transceiver)*1 or speakers.
  1. *1: w/ Manual (SOS) Switch

WIRING DIAGRAM


E230080E13


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the G6 navigation receiver assembly connector.

  1. Disconnect the N11 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N11-5 (R+) - G6-1 (FR+)
    Always
    Below 1 Ω
    N11-4 (R-) - G6-5 (FR-)
    Always
    Below 1 Ω
    N11-3 (L+) - G6-2 (FL+)
    Always
    Below 1 Ω
    N11-2 (L-) - G6-6 (FL-)
    Always
    Below 1 Ω
    N11-6 (SLD) - Body ground
    Always
    10 kΩ or higher
    N11-5 (R+) - Body ground
    Always
    10 kΩ or higher
    N11-4 (R-) - Body ground
    Always
    10 kΩ or higher
    N11-3 (L+) - Body ground
    Always
    10 kΩ or higher
    N11-2 (L-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)