NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
![]() |
Disconnect the G37 navigation receiver assembly connector.
Disconnect the G39 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G37-25 (ADPG) - G39-10 (AUXO) | Always | Below 1 Ω |
| G37-26 (VAR+) - G39-7 (ARO) | Always | Below 1 Ω |
| G37-28 (VAL+) - G39-8 (ALO) | Always | Below 1 Ω |
| G37-27 (VA-) - G39-9 (ASGN) | Always | Below 1 Ω |
| G37-11 (AGND) - G39-12 (AGND) | Always | Below 1 Ω |
| G37-25 (ADPG) - Body ground | Always | 10 kΩ or higher |
| G37-26 (VAR+) - Body ground | Always | 10 kΩ or higher |
| G37-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| G37-27 (VA-) - Body ground | Always | 10 kΩ or higher |
| G37-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||