Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E281763E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    E283480E02
  1. Disconnect the G40 navigation receiver assembly connector.

  1. Disconnect the G39 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G40-2 (US1-) - G39-2 (UDO-)
    Always
    Below 1 Ω
    G40-3 (US1+) - G39-3 (UDO+)
    Always
    Below 1 Ω
    G40-5 (USG1) - G39-5 (UJSS)
    Always
    Below 1 Ω
    G40-2 (US1-) - Body ground
    Always
    10 kΩ or higher
    G40-3 (US1+) - Body ground
    Always
    10 kΩ or higher
    G40-5 (USG1) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)