Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR

BACK DOOR > ADJUSTMENT

for Preparation Click here


HINT:

  1. B216808E01
    Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.
  3. Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts and washers when making adjustments.
  4. The specified torque for standard bolts is shown in the standard bolt chart (Click here).



1. INSPECT BACK DOOR


  1. Check that the clearance measurements of areas A through G are within each standard range.


    B237265E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    9.5 to 12.5 mm (0.374 to 0.492 in.)
    B
    0.0 to 3.0 mm (0.0 to 0.118 in.)
    C
    4.0 to 7.0 mm (0.157 to 0.276 in.)
    D
    4.2 to 7.2 mm (0.165 to 0.283 in.)
    E
    6.4 to 9.4 mm (0.252 to 0.370 in.)
    F
    6.7 to 9.7 mm (0.264 to 0.382 in.)
    G
    8.6 to 11.6 mm (0.339 to 0.457 in.)
    -
    -



2. ADJUST BACK DOOR


    B237266
  1. Before adjusting the upper end of the back door up and down or left and right, loosen the bolts.

  1. Tighten the body side hinge after the adjustment.

    Torque:
    20 N*m{ 199 kgf*cm , 15 ft.*lbf }



    B237267
  1. Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

  1. Using a brass bar and hammer, hit the striker to adjust its position.

  1. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after the adjustment.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }