Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2176/76    Receiver Error

for Preparation Click here


DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC Code
DTC Detection Condition
Trouble Area
C2176/76
A malfunction in the tire pressure warning ECU internal circuit.
  1. Tire pressure warning antenna and receiver
  2. Harness or connector
  3. Tire pressure warning ECU

WIRING DIAGRAM


E133110E23


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced (Click here).

1.CHECK HARNESS AND CONNECTOR (ECU - RECEIVER)
  1. Disconnect the F7 ECU connector.

  1. Disconnect the V3 receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F7-12 (RDA) - V3-1 (RDA)
    Always
    Below 1 Ω
    F7-11 (GND2) - V3-4 (GND)
    Always
    Below 1 Ω
    F7-6 (RF5V) - V3-5 (+5V)
    Always
    Below 1 Ω
    F7-12 (RDA) or V3-1 (RDA) - Body ground
    Always
    10 kΩ or higher
    F7-11 (GND2) or V3-4 (GND) - Body ground
    Always
    10 kΩ or higher
    F7-6 (RF5V) or V3-5 (+5V) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TIRE PRESSURE WARNING ECU


    E137003E22
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F7-6 (RF5V) - F7-11 (GND2)
    Ignition switch ON
    4.5 to 5.5 V

    Text in Illustration 
    *a
    Component with harness connected
    (Tire Pressure Warning ECU)



NG
REPLACE TIRE PRESSURE WARNING ECU (Click here)
OK

REPLACE TIRE PRESSURE WARNING ANTENNA AND RECEIVER (Click here)