Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Confirm problem symptoms (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE*
    1. Measure the voltage of the battery.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CHECK DTC*
    1. Check and record DTCs.


    NEXT


    5.CLEAR DTC*
    1. Clear the DTCs.


    NEXT


    6.PROBLEM SYMPTOM CONFIRMATION
      Result 
      Result
      Proceed to
      Symptom does not occur
      A
      Symptom occurs
      B


    B.
    Go to step 8
    A


    7.SYMPTOM SIMULATION
    1. Perform symptom simulation (Click here).


    NEXT


    8.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTCs (Click here).
      Result 
      Result
      Proceed to
      CAN communication system DTC is not output
      A
      CAN communication system DTC is output
      B

      HINT:
      1. If any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first (Click here).
      2. If communication with the power steering ECU assembly cannot be established through the Techstream, inspect terminals CANH and CANL of the DLC3 and power steering ECU assembly, and the IG circuit of the power steering ECU assembly.



    B.
    PROCEED TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
    A


    9.CHECK FOR DTC*
    1. Check for DTCs (Click here).

      HINT:
      Refer to Diagnostic Trouble Code Chart when any DTCs are output (Click here).

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    Go to step 11
    A


    10.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).


    NEXT


    11.CIRCUIT INSPECTION

      NEXT


      12.IDENTIFICATION OF PROBLEM

        NEXT


        13.REPAIR OR REPLACE

          NEXT


          14.CONFIRMATION TEST

            NEXT

            END