Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0126    Lost Communication with Steering Angle Sensor Module

DTC    U0129    Lost Communication with Brake System Control Module

for Preparation Click here


DESCRIPTION

The power steering ECU assembly receives signals from the ECM, steering angle sensor and master cylinder solenoid (skid control ECU) via the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
U0100
The engine speed signal is lost.
CAN communication system
U0126
The steering angle signal is lost.
CAN communication system
U0129
The vehicle speed signal is lost.
CAN communication system

INSPECTION PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)