Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1541    Vehicle Speed Signal

for Preparation Click here


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the master cylinder solenoid (skid control ECU) via CAN communication. The power steering ECU assembly provides appropriate assisting force in accordance with the vehicle speed signal.

DTC Code
DTC Detection Condition
Trouble Area
C1541
An abnormal vehicle speed signal is received.
  1. Speed sensor circuit
  2. Vehicle stability control system
  3. CAN communication system
  4. Power steering ECU assembly

INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Check if DTC U0129 is output (Click here).
    Result 
    Result
    Proceed to
    DTC U0129 is not output.
    A
    DTC U0129 is output.
    B

    HINT:
    DTC U0129 indicates a CAN communication malfunction in the power steering system.



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
  1. Using the Techstream, check for DTCs and confirm that there are no problems in the vehicle stability control system (Click here).
    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)