Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2313    Back Door Power Window Position/Seal Characteristics Data is not Memorized

for Preparation Click here


DESCRIPTION

The power window regulator motor is driven by operating the back door power window regulator switch. The power window regulator motor assembly has a motor and ECU.
When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:
This DTC may be stored for all the windows.

NOTICE:
  1. When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
  2. After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
    1. Close the power window by fully pulling up the power window switch and holding it in the auto up position.
    2. Open the power window by fully pushing down the power window switch.


Back Door P/W 
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
Back door power window regulator motor

INSPECTION PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
  1. Initialize the power window regulator motor (Click here).


NEXT


2.CHECK DTC
  1. Clear the DTC (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    No DTCs output
    A
    DTC B2313 is output
    B



B
REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY
A

END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)