POWER WINDOW CONTROL SYSTEM > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) |
| 1.PERFORM INITIALIZATION (APPLICABLE LOCATION) |
Initialize the power window regulator motor (applicable location) (Click here).
| NEXT | |
| 2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION)) |
Check that all door power windows move when the auto up/down function of the multiplex network master switch and power window regulator switch (for rear LH and rear RH sides) is operated (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION) |
Remove the power window regulator motor.
Install the window glass to the door glass run.
Check if the power window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
|
| ||||
| OK | ||
| ||