Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER


    A229925E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then detach the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    V-bank Cover Hook



2. REMOVE NO. 1 AIR CLEANER HOSE


    A221455
  1. Disconnect the ventilation hose and vacuum hose.

  1. Detach the wire harness clamp.

  1. Remove the bolt and loosen the 2 hose clamps.

  1. Remove the No. 1 air cleaner hose.



3. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    A221424
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    A221425
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



5. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    A221426
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



6. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    A225395
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.