Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


    A078438E14
  1. Install the 2 sensors with the 2 bolts as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *A
    for Bank 2
    *B
    for Bank 1
    *a
    Engine Rear
    *b
    Top
    *c
    Engine Front

  1. Connect the 2 sensor connectors.



2. INSTALL NO. 1 WATER OUTLET PIPE
  1. Install the water outlet pipe with the 2 nuts and bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Attach the 3 wire harness clamps.



3. INSTALL CYLINDER HEAD SUB-ASSEMBLY (for Bank 1)
  1. Install the cylinder head (Click here).