Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. REMOVE CYLINDER HEAD SUB-ASSEMBLY (for Bank 1)
  1. Remove the cylinder head (Click here).



2. REMOVE NO. 1 WATER OUTLET PIPE


    A227937
  1. Detach the 3 wire harness clamps.

  1. Remove the 2 nuts, bolt and water outlet pipe.



3. REMOVE KNOCK SENSOR


    A075662
  1. Disconnect the 2 sensor connectors.

  1. Remove the 2 bolts and 2 sensors.