Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH

BACK DOOR OUTSIDE GARNISH > REMOVAL

for Preparation Click here



1. REMOVE ASSIST STRAP HOLE COVER


    B326929
  1. Detach the 2 claws and guide to remove the assist strap hole cover.



2. REMOVE ASSIST STRAP ASSEMBLY


    B326930
  1. Remove the bolt and assist strap assembly.



3. REMOVE BACK DOOR TRIM PANEL ASSEMBLY


    B240234
  1. Detach the 12 clips by pulling the back door trim panel assembly.



4. REMOVE MULTIPLEX NETWORK DOOR ECU


    B242092
  1. Disconnect the 3 connectors to detach the 2 clamps.



    B242093
  1. Remove the 3 screws.



    B242094
  1. Using a clip remover, detach the 2 clips to remove the multiplex network door ECU.



5. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER


    B240216
  1. Remove the No. 2 back door service hole cover.

    NOTICE:
    Remove any remaining tape on the back door side.



6. REMOVE BACK DOOR LOCK CYLINDER (w/o Smart Key System)


    B240231
  1. Disconnect the connector.

  1. Remove the 2 nuts and back door lock cylinder.

    HINT:
    Remove the back door lock cylinder through the service hole.



7. REMOVE BACK DOOR OUTSIDE GARNISH (w/o Smart Key System)


B239985
  1. Disconnect the connector.

  1. Remove the 4 nuts.

  1. Detach the 3 clips and remove the back door outside garnish.



8. REMOVE BACK DOOR OUTSIDE GARNISH (w/ Smart Key System)


B239986
  1. Disconnect the 2 connectors.

  1. Remove the 4 nuts.

  1. Detach the 3 clips and back door outside garnish.