Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU
  1. Install the tire pressure warning ECU with the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Install the lower No. 1 instrument panel airbag assembly (Click here).



3. PERFORM REGISTRATION OF TRANSMITTER ID
  1. Perform registration of the transmitter ID (Click here).