THERMOSTAT > INSTALLATION |
| 1. INSTALL WATER INLET WITH THERMOSTAT |
Install a new gasket and the water inlet with thermostat with the 3 nuts.
| 2. CONNECT NO. 2 RADIATOR HOSE |
Connect the No. 2 radiator hose to the water inlet with the clamp.
| 3. ADD ENGINE COOLANT |
Tighten the cylinder block drain cock plug.
Tighten the radiator drain cock plug by hand.
Add engine coolant.
Slowly pour coolant into the radiator reservoir until it reaches the F line.
Install the reservoir cap.
Install the radiator cap.*1
Start the engine and stop it immediately.*2
Allow approximately 10 seconds to pass. Then remove the radiator cap and check the coolant level. If the coolant level has decreased, add coolant.*3
Repeat steps *1, *2 and *3 until the coolant level does not decrease.
Install the radiator cap.*4
Set the air conditioning as follows.*5
| Item | Condition |
| Fan speed | Any setting except off |
| Temperature | Toward WARM |
| Air conditioning switch | Off |
Start the engine, warm it up until the thermostat opens, and then continue to run the engine for several minutes to circulate the coolant.*6
Stop the engine, wait until the engine coolant cools down to ambient temperature. Then remove the radiator cap and check the coolant level.*7
If the coolant level has decreased, add coolant and warm up the engine until the thermostat opens.*8
If the coolant level has not decreased, check that the coolant level in the radiator reservoir is at the F line.
If the coolant level is below the F line, repeat steps *4 through *8.
If the coolant level is above the F line, drain coolant until the coolant level reaches the F line.
| 4. INSPECT FOR ENGINE COOLANT LEAK |
Fill the radiator with engine coolant, and then attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 123 kPa (1.3 kgf/cm2, 18 psi), and then check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leakage. If there are no signs or traces of external engine coolant leakage, check the heater core, cylinder block and head.
| 5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
![]() |
Hook the No. 1 engine under cover sub-assembly to the vehicle body as shown in the illustration.
Install the 4 bolts.
| 6. INSTALL FRONT LOWER BUMPER COVER (w/o Intuitive Parking Assist System) |
Install the front lower bumper cover with the 5 bolts and clip.
| 7. INSTALL AIR INTAKE DUCT LH (w/ Intuitive Parking Assist System) |
Install the air intake duct LH with the 2 screws.
Install the clip and bolt.
| 8. INSTALL AIR INTAKE DUCT RH (w/ Intuitive Parking Assist System) |
| 9. INSTALL FRONT LOWER BUMPER COVER (w/ Intuitive Parking Assist System) |
Install the front lower bumper cover with the 4 bolts and clip.
| 10. INSTALL COOL AIR INTAKE DUCT (for 4WD with Intuitive Parking Assist System) |
Install the cool air intake duct with the 4 clips.
| 11. INSTALL V-BANK COVER |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins and press down on the V-bank cover to attach the pins.
| *1 | Pin |
| *2 | V-bank Cover Hook |
| 12. INSTALL UPPER RADIATOR SUPPORT SEAL |
Install the upper radiator support seal with the 13 clips.