AUTOMATIC TRANSMISSION FLUID > ADJUSTMENT |

| 1. BEFORE FILLING TRANSMISSION |
| 2. TRANSMISSION FILL |
![]() |
Remove the refill plug and overflow plug.
| *1 | Refill Plug |
| *2 | Overflow Plug |
| *3 | Refill Hole |
![]() |
Fill the transmission through the refill hole until fluid begins to trickle out of the overflow tube.
| *1 | Overflow Tube |
| *a | Specified fluid level |
Reinstall the overflow plug.
Fill the transmission with the amount of fluid listed in the table below.
| Repair | Fill Amount |
| Transmission pan and drain plug removal | 1.7 liters (1.8 US qts, 1.5 Imp. qts) |
| Transmission valve body removal | 4.3 liters (4.5 US qts, 3.8 Imp. qts) |
| Torque converter removal | 5.4 liters (5.7 US qts, 4.8 Imp. qts) |
Install the refill plug.
Start the engine and idle it.
Move the shift lever through the entire gear range to circulate the fluid.
Wait for 30 seconds with the engine idling.
Stop the engine.
Remove the refill plug.
Fill the transmission with the remaining fluid until the amount in the table has been filled.
Install the refill plug.
| 3. FLUID TEMPERATURE CHECK |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / ECT / Data List / A/T Oil Temperature 1.
Check the ATF temperature.
| 4. FLUID LEVEL CHECK |
When using the Techstream:
Enter the following menus: Powertrain / ECT / Active Test / Connect the TC and TE1.
![]() |
When not using the Techstream:
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
| *1 | Front view of DLC3: |
Start the engine and idle it.
Slowly move the shift lever from P to S, and then change the gear from 1st to 5th. Then return the shift lever to P.
![]() |
Move the shift lever to D, and quickly move it back and forth between N and D (once within 1.5 seconds) for at least 6 seconds. This will activate the fluid temperature detection mode.
When using the Techstream:
Return the shift lever to P and terminate the Active Test on the Techstream.
When not using the Techstream:
Return the shift lever to P and disconnect SST from the DLC3.
Allow the engine to idle until the fluid temperature reaches 40 to 45°C (104 to 113°F).
| Below 40°C (104°F) | 40 to 45°C (104 to 113°F) | Higher than 45°C (113°F) |
| Turn off | Turn on | Blinking |
![]() |
Remove the overflow plug and gasket with the engine idling.
Wait until the overflow slows to a trickle.
| *1 | Overflow Tube |
| *a | Specified fluid level |
Remove the refill plug and gasket.
Refill the transmission through the refill hole until fluid begins to trickle out of the overflow tube.
Wait until the overflow slows to a trickle.
Install a new gasket and the overflow plug.
Install a new gasket and the refill plug.
| 5. COMPLETE |
Turn the ignition switch off.
When using the Techstream:
Disconnect the Techstream from the DLC3.
Inspect for automatic transmission fluid leak.