Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2312    Back Door Power Window Switch ON Stuck

for Preparation Click here


DESCRIPTION

This DTC is stored when the back door power window regulator motor is stuck.

NOTICE:
When a power window regulator is reinstalled or replaced, the power window control system must be initialized.


Back Door P/W 
DTC Code
DTC Detection Condition
Trouble Area
B2312
The back door power window regulator motor is stuck.
  1. Multiplex network door ECU (Back door P/W)
  2. Back door power window regulator motor
  3. Harness or connector

WIRING DIAGRAM


B245647E01


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    No DTCs output
    A
    DTC B2312 is output
    B



B
Go to step 2
A

END 

2.CHECK MULTIPLEX NETWORK DOOR ECU (BACK DOOR P/W)


  1. Measure the resistance according to the value(s) in the table below.


    B245651E01

    Standard Voltage:
    Tester Connection
    Tool Setting
    Switch Condition
    Specified Condition
    W10-14 (BUP2) - W10-1 (E4)
    2 V/DIV., 100 ms/DIV.
    Ignition switch ON, back door power window regulator switch up
    Pulse generation (See waveform 1
    W10-13 (BDN2) - W10-1 (E4)
    2 V/DIV., 100 ms/DIV.
    Ignition switch ON, back door power window regulator switch down
    Pulse generation (See waveform 1)
    W10-12 (AUT2) - W10-1 (E4)
    2 V/DIV., 100 ms/DIV.
    Ignition switch ON, back door power window auto up or auto down function operating
    Pulse generation (See waveform 2)



NG
REPLACE MULTIPLEX NETWORK DOOR ECU (BACK DOOR P/W)
OK


3.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK DOOR ECU - BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY)
  1. Disconnect the W9 back door power window regulator motor connector.

  1. Disconnect the W10 multiplex network door ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    W9-10 (UP) - V10-14 (BUP2)
    Always
    Below 1 Ω
    W9-7 (DOWN) - V10-13 (BDN2)
    Always
    Below 1 Ω
    W9-4 (AUTO) - V10-12 (AUT2)
    Always
    Below 1 Ω
    W9-1 (GND) - V10-1 (E4)
    Always
    Below 1 Ω
    W9-10 (UP) - Body ground
    Always
    10 kΩ or higher
    W9-7 (DOWN) - Body ground
    Always
    10 kΩ or higher
    W9-4 (AUTO) - Body ground
    Always
    10 kΩ or higher
    W9-1 (GND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY