Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > INSPECTION

for Preparation Click here



1. INSPECT FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH


    G021680
  1. As shown in the illustration, flip the ball joint stud back and forth 5 times before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take a torque reading on the 5th turn.

    Standard turning torque:
    0.29 to 2.94 N*m (2.96 to 30.0 kgf*cm, 2.57 to 26.02 in.*lbf) or less