Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER (w/ REAS)

REAR SHOCK ABSORBER (w/ REAS) > INSTALLATION

for Preparation Click here


NOTICE:
Be sure to read the precaution before performing this procedure (Click here).

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
  1. Install the cushion No. 2 to the rear shock absorber assembly LH.



    C214812
    C216505
  1. Install the cushion retainer, cushion No. 1 and rear shock absorber assembly LH with the nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Be sure to fit the positioning protrusion of the bracket into a hole on the frame.

  1. Install the rear shock absorber assembly LH with the bolt.

  1. Install the bracket with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Using a wrench to hold the bracket, install the joint.

    HINT:
    Tighten the joint so that the gap is 1 mm (0.0394 in.).

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. INSTALL REAR STABILIZER LINK ASSEMBLY
  1. Install the stabilizer link with a new nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

  1. Install the 2 retainers and cushion to the stabilizer link.

  1. Hold the stabilizer bar link with a wrench, and then install the retainer, cushion and link with a new nut.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }



3. INSTALL REAR WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



5. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
  1. Tighten the bolt.

    Torque:
    98 N*m{ 999 kgf*cm , 72 ft.*lbf }



6. INSPECT FOR FLUID LEAK
  1. Inspect for fluid leaks .