Home › Suspension › REAR SUSPENSION › REAR UPPER ARM

REAR UPPER ARM > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH
  1. Temporarily install the upper control arm assembly and washer with the nut and bolt.

  1. Temporarily install the upper control arm assembly and washer to the rear axle housing with the nut and bolt.



2. INSTALL REAR WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }



3. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



4. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH


    D029806E01
  1. Tighten the 2 nuts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

    HINT:
    Turn the nut while holding the bolt.