Home › Suspension › REAR SUSPENSION › REAR UPPER ARM

REAR UPPER ARM > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH


    D029803
  1. Remove the nut, washer and bolt from the rear axle housing.

    HINT:
    Turn the nut while holding the bolt.



    D029804
  1. Remove the nut, washer, bolt and upper control arm assembly.

    HINT:
    Turn the nut while holding the bolt.