Home › Suspension › SUSPENSION CONTROL › CENTER CONTROL ABSORBER (w/ REAS)

CENTER CONTROL ABSORBER (w/ REAS) > REMOVAL

for Preparation Click here


NOTICE:
Be sure to read PRECAUTION before performing this procedure (Click here).



1. REMOVE FRONT WHEEL


2. REMOVE REAR WHEEL


3. REMOVE CENTER CONTROL ABSORBER ASSEMBLY LH


    C212827
  1. While using a wrench to hold the bracket, disconnect the joint.

    NOTICE:
    Check that all four shock absorbers are fully extended to the normal suspension rebound point.

  1. Remove the bolt and disconnect the bracket.



    C212829
  1. Disconnect the tube from the 2 clamps.



    C212828
  1. While using a wrench to hold the center control absorber assembly, disconnect the joint.

    NOTICE:
    1. Do not loosen the flare nut.
    2. Do not deform or damage the tubes.



    C212830
  1. Remove the 3 nuts and center control absorber assembly.

    NOTICE:
    1. Do not deform or damage the tubes.
    2. Be sure to hold the center control absorber assembly by the body when carrying it.



4. REMOVE CENTER CONTROL ABSORBER ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE TUBE PROTECTOR LH


    C214834
  1. Remove the bolt and tube protector LH.



6. REMOVE TUBE PROTECTOR RH

HINT:
Use the same procedure described for the LH side.



7. REMOVE NO. 1 CENTER CONTROL ABSORBER TUBE LH


    C214836
  1. While using a wrench to hold the bracket, disconnect the joint.



    C212834E01
  1. Using pliers, cut the center control absorber tube. Use a container to catch suspension fluid as it drains out.
    Text in Illustration 
    *a
    Cut

  1. Detach the 3 clamps from the frame.



    C212835
  1. Detach the 2 clamps.

  1. Remove the No. 1 center control absorber tube LH.



8. REMOVE NO. 1 CENTER CONTROL ABSORBER TUBE RH

HINT:
Use the same procedure described for the LH side.



9. REMOVE CENTER CONTROL ABSORBER BRACKET LH


    C214855
  1. Remove the 2 bolts and center control absorber bracket LH from the frame.



10. REMOVE CENTER CONTROL ABSORBER BRACKET RH

HINT:
Use the same procedure described for the LH side.