Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE OUTER MIRROR LH
  1. Put protective tape around the outer mirror LH.



    B354456E01
  1. Using a moulding remover, detach the 2 claws of the outer mirror LH as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover
    *2
    Protective Tape



    B354457E01
  1. Using a moulding remover, detach the 2 claws of the outer mirror LH as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover
    *2
    Protective Tape



    B354477
  1. Disconnect the connector and remove the outer mirror LH.



2. REMOVE OUTER MIRROR COVER LH


    B339719
  1. Detach the 7 claws to remove the outer mirror cover LH.



3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
  1. Retract the outer rear view mirror assembly LH.



    E280439
  1. Remove the 2 screws.

  1. Detach the 4 claws.



    E280437
  1. Turn the socket in the direction indicated by the arrow to remove the body cover.



    E280427
  1. Detach the 2 claws.

  1. Disconnect the connector and remove the side turn signal light assembly LH.