Home › Engine / Hybrid System › 1GR-FE EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE SPARE TIRE


2. REMOVE CANISTER ASSEMBLY


    A225429E01
  1. Disconnect the connector.

  1. Disconnect the purge line hose.
    Text in Illustration 
    *1
    Vent Line Hose
    *2
    Air Inlet Line Hose
    *3
    Canister
    V100136
    Pull Out
    V100137
    Pinch

  1. Disconnect the air inlet line hose.

    1. Push the hose firmly toward the canister side.

    2. Pinch the hose as shown in the illustration.

    3. Pull out the hose.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.

  1. Disconnect the vent line hose.

    1. Pinch the retainer and then raise it.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.



    A225361
  1. Detach the claw, and remove the 3 bolts and canister.