Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR (w/ KDSS)

FRONT STABILIZER BAR (w/ KDSS) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE SIDE STEP ASSEMBLY LH


  1. Remove the 6 bolts and side step.


    B239976



3. REMOVE STABILIZER CONTROL VALVE PROTECTOR


    C212853
  1. Remove the 2 bolts and stabilizer control valve protector.



4. DRAIN SUSPENSION FLUID


    C212854
  1. Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.

    HINT:
    1. Drain suspension fluid when performing operations related to the hydraulic circuits.
    2. Draining suspension fluid decreases suspension fluid pressure.

  1. Tighten the bleeder plug.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



5. REMOVE LOWER FRONT BUMPER COVER
  1. Remove the clip, 5 bolts and front lower bumper cover.



6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



7. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY


    C214451
  1. Remove the 6 bolts and 2 member braces from the front frame assembly.



8. REMOVE FRONT STABILIZER END BRACKET


    C214452
  1. Remove the 4 bolts and 2 brackets from the lower arm.



9. REMOVE FRONT STABILIZER BAR


    F047879
  1. Remove the 4 bolts, 2 front stabilizer lower brackets and front stabilizer bar.

  1. Remove the 2 front stabilizer link bushes and front stabilizer lower bracket bushes from the front stabilizer bar.



10. REMOVE FRONT FENDER APRON SEAL LH


    F047880
  1. Remove the 7 clips and front apron seal LH.



11. REMOVE FRAME APRON SEAL BRACKET


    C214454
  1. Remove the bolt and bracket.



12. DISCONNECT NO. 1 FRONT STABILIZER CONTROL TUBE ASSEMBLY


    C214455
  1. Using a union nut wrench, disconnect the 2 front stabilizer control tubes.

  1. Remove the bolt.



13. REMOVE FRONT STABILIZER WITH TUBE CYLINDER ASSEMBLY


    C214456
  1. Remove the bolt, nut and front stabilizer with tube cylinder assembly.

    NOTICE:
    1. Turn the bolt while holding the nut.

    2. F048085E02
      Do not loosen or remove the flare nuts labeled A and B in the illustration.
    3. Do not hold the front stabilizer with tube cylinder assembly by the cylinder boot.

  1. Remove the 2 bleeder plug caps and bleeder plugs from the front stabilizer with tube cylinder assembly.



14. REMOVE FRONT STABILIZER LINK ASSEMBLY RH


    C214457
  1. Remove the bolt and front stabilizer link assembly.