Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (w/ KDSS)

REAR STABILIZER BAR (w/ KDSS) > REMOVAL

for Preparation Click here



1. REMOVE SIDE STEP ASSEMBLY LH


  1. Remove the 6 bolts and side step.


    B239976



2. REMOVE STABILIZER CONTROL VALVE PROTECTOR


    C212853
  1. Remove the 2 bolts and stabilizer control valve protector.



3. DRAIN SUSPENSION FLUID


    C212854
  1. Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.

    HINT:
    1. Drain suspension fluid when performing operations related to the hydraulic circuits.
    2. Draining suspension fluid decreases suspension fluid pressure.

  1. Tighten the bleeder plug.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



4. REMOVE REAR STABILIZER LOWER BRACKET


    C214450
  1. Remove the 4 bolts and 2 rear stabilizer lower brackets.



5. REMOVE REAR STABILIZER BAR SUB-ASSEMBLY


    C214762
  1. Remove the 2 bolts, 2 nuts and rear stabilizer bar.

    NOTICE:
    Turn the bolts while holding the nuts.

  1. Remove the 2 stabilizer bushes from the rear stabilizer bar.



6. DISCONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY


    C214763
  1. Remove the 2 union bolts and 2 pressure port gaskets and disconnect the rear stabilizer control tube from the rear stabilizer control cylinder.



7. REMOVE REAR STABILIZER CONTROL CYLINDER


    C214764
  1. Remove the bolt, nut and rear stabilizer control cylinder.

    NOTICE:
    Do not hold the rear stabilizer control cylinder by the cylinder boot.

    HINT:
    Turn the nut while holding the bolt.

  1. Remove the 2 bleeder plug caps from the rear stabilizer control cylinder.



8. REMOVE REAR STABILIZER LINK ASSEMBLY


    C214765
  1. Remove the bolt, nut and rear stabilizer link assembly.

    HINT:
    Turn the nut while holding the bolt.