Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected .



2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH


    B240006E01
  1. Put protective tape around the door scuff plate assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides to remove the door scuff plate assembly LH.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Partially remove the front door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed .



4. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)


    B238730E01
  1. Using a screwdriver, detach the 2 claws to remove the rear No. 1 floor step cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for all the rear No. 1 floor step covers.



5. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)


    B238731
  1. Remove the 2 bolts and quarter scuff plate LH.



6. REMOVE REAR DOOR SCUFF PLATE LH
  1. Put protective tape around the rear door scuff plate LH.



    B240011E02
  1. Using a screwdriver, detach the 3 clips, 6 claws and 2 guides to remove the rear door scuff plate LH.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Partially remove the rear door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed .



8. REMOVE OUTER LAP BELT ANCHOR COVER


    B238735
  1. Detach the 3 claws to remove the outer lap belt anchor cover.

    HINT:
    Use the same procedure for the other outer lap belt anchor cover.



9. REMOVE LOWER CENTER PILLAR GARNISH LH


    B238736
  1. Remove the bolt and disconnect the front seat outer belt floor anchor.



    B238737
  1. Detach the 4 claws and 2 clips and remove the lower center pillar garnish.



10. REMOVE CENTER PILLAR GARNISH LH


    B240017
  1. Move the front shoulder belt anchor adjuster to the lowest position.

  1. Remove the bolt.

  1. Detach the 2 clips and 2 guides.

  1. Pass the front seat outer belt floor anchor through the center pillar garnish LH to remove the center pillar garnish LH.



11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


B241717
  1. Remove the nut and shoulder anchor.



    B239043
  1. Disconnect the pretensioner connector.



    B245756
  1. Remove the bolt and seat belt.



12. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY


B239046
  1. Remove the 2 bolts and anchor plate.