Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    B234372
  1. Detach the bracket claw and remove the bracket.

  1. Remove the 2 bolts and drive gear.



2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY



B234373E01


Text in Illustration 
*a
Rearward
-
-
  1. Remove the 2 screws.

  1. Detach the 4 claws and remove the sliding roof piece LH and RH.

  1. Slide and remove the trim.



3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH


    B178631
  1. Remove the stopper.



4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.



  1. Remove the 2 screws and 2 stoppers.


    B234374



    B234375E01
  1. Using a screwdriver, detach the 2 claws and slide the rear roof drip channel rearward to remove it.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Rearward

    HINT:
    Tape the screwdriver tip before use.



    B234376
  1. Hold down the window deflector.



    B234377E01
  1. Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.
    Text in Illustration 
    *1
    Matchmark A
    *2
    Matchmark B



    B234378E01
  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.
    Text in Illustration 
    *1
    Protective Tape
    V100135
    Slide

    HINT:
    Tape the screwdriver tip before use.