Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    B234379
  1. Hold down the window deflector.

    NOTICE:
    Make sure that the spring indicated by the arrow in the illustration is securely installed.



    B234380E01
  1. Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape
    V100135
    Slide



    B234381E01
  1. Slide the rear roof drip channel forward and attach the 2 claws to install it.
    Text in Illustration 
    *a
    Forward



  1. Install the 2 stoppers with the 2 screws.


    B234374



2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


B234382E03
  1. Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Matchmark A
    *2
    Matchmark B
    *3
    Protective Tape



3. INSTALL SLIDING ROOF SUNSHADE STOPPER LH


    B178631
  1. Install the stopper.



4. INSTALL SLIDING ROOF SUNSHADE STOPPER RH

HINT:
Use the same procedures described for the LH side.



5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


  1. Insert the sunshade trim into the sliding roof housing.


    B234383E01


    Text in Illustration 
    *a
    Forward
    -
    -

  1. Attach the 4 claws to install the sliding roof piece LH and RH.

  1. Install the 2 screws.



6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
  1. Install the drive gear with the 2 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    B234372
  1. Attach the bracket claw to install the bracket.