Home › Drivetrain · A750E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK SHIFT LOCK OPERATION
  1. Move the shift lever to P.

  1. Turn the ignition switch off.

  1. Check that the shift lever cannot be moved from P.

  1. Turn the ignition switch to on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.
    If the operation cannot be performed as specified, inspect the transmission floor shift assembly and shift lock control ECU.



2. CHECK SHIFT LOCK RELEASE BUTTON OPERATION
  1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position.
    If the operation cannot be performed as specified, check the transmission floor shift assembly.



3. CHECK SHIFT LOCK CONTROL ECU


C216999E01
  1. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard Voltage and resistance:
    Tester Connection
    Condition
    Specified Condition
    F75-8 (IG) - F75-1 (E)
    Ignition switch ON
    11 to 14 V
    F75-8 (IG) - F75-1 (E)
    Ignition switch off
    Below 1 V
    F75-4 (STP) - F75-1 (E)
    Brake pedal depressed
    11 to 14 V
    F75-4 (STP) - F75-1 (E)
    Brake pedal released
    Below 1 V
    F75-1 (E) - Body ground
    Always
    Below 1 Ω



    C217000E01
  1. Disconnect the shift lock solenoid connector from the shift lock control ECU.

  1. Measure the voltage according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (SLS+) - 2 (SLS-)
    Ignition switch off
    Below 1 V
    1 (SLS+) - 2 (SLS-)
    Ignition switch ON
    Below 1 V
    Ignition switch ON and brake pedal depressed
    11 to 14 V

    Text in Illustration 
    *a
    Component without harness connected
    (Shift Lock Control ECU)
    If the result is not as specified, replace the transmission floor shift assembly.



4. CHECK SHIFT LOCK SOLENOID


C217001E01
  1. Disconnect the shift lock solenoid connector from the shift lock control ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (SLS+) - 2 (SLS-)
    Always
    101 to 123 Ω
    3 (E2) - 4 (P)
    Shift lever in P
    10 kΩ or higher
    3 (E2) - 4 (P)
    Shift lever not in P
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected:
    (Shift Lock Control Solenoid)

  1. Apply 12 V of battery voltage to the shift lock solenoid and check that the valve moves and makes an operating noise.

    OK:
    Measurement Condition
    Specified Condition
    1. Battery positive (+) → Terminal 1 (SLS+)
    2. Battery negative (-) → Terminal 2 (SLS-)
    Solenoid moves and makes an operating noise

    If the result is not as specified, replace the transmission floor shift assembly.