Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CRUISE CONTROL MAIN SWITCH


  1. Remove the cruise control main switch.


    B215369E03


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:

      Tester Connection
      Switch Condition
      Specified Condition
      1 (ECC) - 3 (CCS)
      Neutral
      1 MΩ or higher
      1 (ECC) - 3 (CCS)
      +RES
      235 to 245 Ω
      1 (ECC) - 3 (CCS)
      -SET
      617 to 643 Ω
      1 (ECC) - 3 (CCS)
      CANCEL
      1509 to 1571 Ω
      1 (ECC) - 3 (CCS)
      Main switch off
      1 MΩ or higher
      1 (ECC) - 3 (CCS)
      Main switch on
      Below 2.5 Ω

      1. If the result is not as specified, replace the cruise control main switch.