Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

DTC    U0100/71    Lost Communication with ECM/PCM "A"

DTC    U0122/71    Lost Communication with Vehicle Dynamics Control Module

DTC    U0124/71    Lost Communication with Lateral Acceleration Sensor Module

DTC    U0126/71    Lost Communication with Steering Angle Sensor Module

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0100/71
While driving at 30 km/h (19 mph), the ECM indicates a CAN communication stop for 3 seconds or more.
CAN communication system
U0122/71
The skid control ECU indicates a CAN communication stop for 3 seconds or more.
CAN communication system
U0124/71
The yaw rate sensor indicates a CAN communication stop for 3 seconds or more.
CAN communication system
U0126/71
The steering angle sensor indicates a CAN communication stop for 3 seconds or more.
CAN communication system

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check for DTCs (Click here).
    Result 
    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B

    HINT:
    If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)