Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B353455
  1. Turn the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)


    B353456
  1. Turn the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B245140E01
  1. Put protective tape around the upper console panel sub-assembly.
    Text in Illustration 
    *1
    Protective Tape



  1. Using a moulding remover, detach the 10 clips.


    B354447E01


    Text in Illustration 
    *A
    for VF2A
    *B
    for VF2BM, VF4BM
    *C
    for 2WD
    -
    -
    *1
    Protective Tape
    -
    -

  1. Disconnect each connector and remove the upper console panel sub-assembly.



4. REMOVE INDOOR NO. 1 ELECTRICAL KEY ANTENNA ASSEMBLY


    B237296
  1. Disconnect the connector.

  1. Detach the clamp and remove the indoor No. 1 electrical key antenna.