Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH

POWER WINDOW MASTER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY


B165342E04
  1. Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LEDs illuminate.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 18 (LED)
      Battery negative (-) → 12 (GND)
      LEDs illuminate

      1. If the result is not as specified, replace the multiplex network master switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Multiplex Network Master Switch Assembly)
      *b
      LED