Home › Vehicle Exterior › WINDOW / GLASS › BACK POWER WINDOW SWITCH

BACK POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B241756E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (UP) - 1 (E)
    Manual up operation
    Below 1 Ω
    7 (DOWN) - 1 (E)
    Manual down operation
    Below 1 Ω
    8 (AUTO) - 1 (GND)
    Auto up/down operation
    Below 1 Ω
    6 (UP) - 1 (E)
    Not operated
    10 kΩ or higher
    7 (DOWN) - 1 (E)
    Not operated
    10 kΩ or higher
    8 (AUTO) - 1 (GND)
    Not operated
    10 kΩ or higher

    1. If the result is not as specified, replace the back door power window regulator switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Power Window Regulator Switch Assembly)