FRONT PASSENGER SIDE POWER WINDOW SWITCH > INSPECTION |
| 1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (UP) - 1 (GND) | Manual up operation | Below 1 Ω |
| 7 (DOWN) - 1 (GND) | Manual down operation | Below 1 Ω |
| 8 (AUTO) - 1 (GND) | Auto up/down operation | Below 1 Ω |
| 6 (UP) - 1 (GND) | Not operated | 10 kΩ or higher |
| 7 (DOWN) - 1 (GND) | Not operated | 10 kΩ or higher |
| 8 (AUTO) - 1 (GND) | Not operated | 10 kΩ or higher |
Check that the LED illuminates.
Apply battery voltage to the power window regulator switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 4 (LED) Battery negative (-) → 1 (GND) | LED illuminates |
| *1 | LED |
| *a | Front view of wire harness connector (Power Window Regulator Switch Assembly) |