Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B218617E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (UP) - 1(GND)
    Manual up operation
    Below 1 Ω
    7 (DOWN) - 1 (GND)
    Manual down operation
    Below 1 Ω
    8 (AUTO) - 1 (GND)
    Auto up/down operation
    Below 1 Ω
    6 (UP) - 1 (GND)
    Not operated
    10 kΩ or higher
    7 (DOWN) - 1 (GND)
    Not operated
    10 kΩ or higher
    8 (AUTO) - 1 (GND)
    Not operated
    10 kΩ or higher

    1. If the result is not as specified, replace the rear power window regulator switch assembly.

  1. Check that the LED illuminates.

    1. Apply battery voltage to the power window regulator switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (LED)
      Battery negative (-) → 1 (GND)
      LED illuminates

      1. If the result is not as specified, replace the rear power window regulator switch assembly.
      Text in Illustration 
      *1
      LED
      *a
      Front view of wire harness connector
      (Power Window Regulator Switch Assembly)