Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door)

POWER WINDOW REGULATOR MOTOR (for Rear Door) > INSPECTION

for Preparation Click here



1. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B180611E06
  1. Check that the motor gear rotates smoothly as follows.

    NOTICE:
    Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.


    OK:

    Measurement Condition
    Specified Condition
    1. Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery cable to terminal 1 (GND), and keep them connected for 3 seconds or more.
    2. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP).
    3. Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second.
    Motor gear rotates clockwise (Up)
    1. Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.
    2. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN).
    3. Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second.
    Motor gear rotates counterclockwise (Down)

    1. If the result is not as specified, replace the rear power window regulator motor assembly.

    CAUTION:
    Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.

    Text in Illustration 
    *a
    Motor Gear
    *b
    Clockwise
    *c
    Counterclockwise



2. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    B175750E08
  1. Check that the motor gear rotates smoothly as follows.

    NOTICE:
    Do not apply positive (+) battery voltage to any terminals except terminal 2 (B) to avoid damaging the pulse sensor inside the motor.


    OK:

    Measurement Condition
    Specified Condition
    1. Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.
    2. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 10 (UP).
    3. Disconnect and reconnect the negative (-) battery terminal to terminal 10 (UP) within 1 second.
    Motor gear rotates counterclockwise (Up)
    1. Connect the positive (+) battery terminal to terminal 2 (B), and connect the negative (-) battery terminal to terminal 1 (GND), and keep them connected for 3 seconds or more.
    2. With terminals 2 (B) and 1 (GND) connected to the battery, connect the negative (-) battery terminal to terminal 7 (DOWN).
    3. Disconnect and reconnect the negative (-) battery terminal to terminal 7 (DOWN) within 1 second.
    Motor gear rotates clockwise (Down)

    1. If the result is not as specified, replace the rear regulator motor assembly.

    CAUTION:
    Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly to the door.

    Text in Illustration 
    *a
    Motor Gear
    *b
    Clockwise
    *c
    Counterclockwise