LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between front power window regulator motor assembly LH and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication P-Door Motor | Connection status between front power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication RR-Door Motor | Connection status between rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication RL-Door Motor | Connection status between rear power window regulator motor assembly LH and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication Slide Roof* | Connection status between sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Communication Master SW | Connection status between power window regulator master switch assembly and main body ECU (multiplex network body ECU) / OK or STOP | OK: Connection STOP: No connection | When there is a malfunction, a DTC is stored. |
| Number of Trouble Codes | Number of trouble codes / Min.: 0, Max.: 255 | Number of stored DTCs displayed | - |