Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > Air Conditioning Control Panel does not Operate

for Preparation Click here


DESCRIPTION

When a switch of the air conditioning control assembly is operated, the air conditioning control assembly uses LIN communication to communicate with the air conditioning amplifier. If a switch of the air conditioning control assembly does not operate properly, a problem with the LIN communication between the air conditioning control assembly and air conditioning amplifier may be causing the malfunction.

WIRING DIAGRAM


C217430E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - AIR CONDITIONING CONTROL)
  1. Disconnect the F42 air conditioning amplifier assembly connector.

  1. Disconnect the F29 air conditioning control assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F42-37 (LIN1) - F29-10 (LIN1)
    Always
    Below 1 Ω
    F42-37 (LIN1) or F29-10 (LIN1) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (for Automatic Air Conditioning System)
    A
    OK (for Manual Air Conditioning System)
    B
    NG
    C



B
Go to AIR CONDITIONING SYSTEM (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

Go to AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) (Click here)