Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT

LIGHT CONTROL RHEOSTAT > INSPECTION

for Preparation Click here



1. INSPECT LIGHT CONTROL RHEOSTAT (w/o TAIL Cancel Switch)


  1. Measure the resistance according to the value(s) in the table below.


    E200224E01

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (T) - 1 (E)
    Always
    8 to 12 kΩ
    3 (RV) - 1 (E)
    Light control rheostat fully turned upward → fully turned downward
    8 to 12 kΩ → Below 50 Ω

    If the result is not as specified, replace the rheostat.



2. INSPECT LIGHT CONTROL RHEOSTAT (w/ TAIL Cancel Switch)


  1. Measure the resistance according to the value(s) in the table below.


    E200225E01

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (T) - 1 (E)
    Always
    8 to 12 kΩ
    5 (TC) - 7 (T)
    TAIL cancel switch off → on
    1 MΩ or higher → Below 1 Ω
    3 (RV) - 1 (E)
    Light control rheostat fully turned upward → fully turned downward
    8 to 12 kΩ → Below 50 Ω

    If the result is not as specified, replace the rheostat.