Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH LH


B242239E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (SW) - 7 (RV)
    Switch off
    2.7 to 4.1 kΩ
    Switch on (Min.)
    Switch on (Max.)
    0.28 to 0.42 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the seat heater switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Seat Heater Switch)

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 8 (ILL+)
    Battery negative (-) → 2 (ILL-)
    Illuminates

    If the result is not as specified, replace the seat heater switch.

  1. Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → 9 (IG)
    Battery negative (-) → 4 (E)
    Switch on
    Indicator illuminates

    If the result is not as specified, replace the seat heater switch.



2. INSPECT SEAT HEATER SWITCH RH


B242240E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    2 (SW) - 5 (RV)
    Switch off
    2.7 to 4.1 kΩ
    Switch on (Min.)
    Switch on (Max.)
    0.28 to 0.42 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the seat heater switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Seat Heater Switch)

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 6 (ILL+)
    Battery negative (-) → 1 (ILL-)
    Illuminates

    If the result is not as specified, replace the seat heater switch.

  1. Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → 7 (IG)
    Battery negative (-) → 3 (E)
    Switch on
    Indicator illuminates

    If the result is not as specified, replace the seat heater switch.